Switches - Small Business

Hello,   I just purchased a new SF-300 managed switch for the purpose of using it on the DMZ, so we can mirror the internet port and monitor traffic for my company.  I have set it up from the web interface to miror port 1 to port 2 and that's pretty ...

I have a Cisco SG300-20.I have read the documentation and cannot seem to locate the instructions for port forwarding.I need to forward TCP port 8088 to IP address 192.168.14.110 on the switch.How do I accomplish this?All assistance is appreciated.Tha...

Hi everybody,I am having an issue with LAG configuration on a Cisco SG300 52 switch. I have connected four Ge ports on the switch to the four NICs of a Dell R710 Server on which I installed Windows Server 2008 R2. Without LAG configured, these ports ...

I lost the rack brackets for my switch in a recent move. Where can I get more?

Hi:I'm planning to separate voice and data traffic with two vlans.  I have a COR switch catalyst 3750, a UC560 for VOIP with SIP trunk and SGE2000P as access switches.  The thing is i had configured VLAN1 (data vlan) and VLAN8 (voice vlan), i've crea...

Dear all,I have configured the two L2 SF200 switches connected uplink to L3 but when we connect back-2-back SF200 we are getting looped. Kindly support to provide the sample configuration @ your earliest. attached is my configuration, what I want tha...

We are about to install a new VoIP system (Allworx, which I did not select) and need to set up a new VLAN with QOS quickly for my SG 300 and SG 200 switches.  I have the default VLAN1  at 10.0.0.0/24 and will be setting up VLAN10 at 10.1.0.0/24 for v...

Hi,We bought 2 new small business SG300-20 switchesI've been looking into configurating them. They work fineBut i also found this "host mapping"I filled in an IP + DNSbut when i then try to ping the name it can't find it.What should i do to get it ri...

I need to confure 3 ESW-520, 2 24 ports and 1 48 ports, connected in etherlink on the same vlan. One of the 24 ports and the 48 ports works perfectly, the other 24 ports it working, i can use it as a flat switch, i can also access from the console, b...

We have a stack of 2 SGE2010s and 1 SGE2000. They are set to layer 3 mode and are routing between several VLANs.  There are also several static routes, each representing a building on our WAN.  The WAN is a leased fiber connection with 10 Mb/s of ban...

The usuual way to log ont a cisco switch is by username then password authenticated by TACACS. The you go into enable mode again authenticated by TACACS.The SMB 300's only have usename and password at login on the GUI and when you nget to the CLI it ...

I wanted to run this plan by some others before I screw something up.Client is adding 2nd WAN link via wireless.  There is not additional cabling from the wireless location down to the control room but there is a switch nearby.  All switches are ESW-...

Hi all,Setup consists of:adsl router - 192.168.1.1sg 300 switch - 192.168.1.2dlink 8600ap WAP - 192.168.1.3win 2003 server - 192.168.1.20I would like to config two IP ranges, one for staff, one for guest wireless access. The dlink wap supports multi ...

Hi There Do the following Moduls GLC-BX-D= / GLC-BX-U work with the Small Business Switches??Best regards