cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
192
Views
0
Helpful
6
Replies

Cisco SG200 26 Boot Loop

Anyone know how to fix a boot loop on a SG200 26 without a console?

6 Replies 6

Kasun Bandara
VIP Advisor VIP Advisor
VIP Advisor

you need to find out what is the reason for boot loop. you can try resetting switch to default config without console. if that is not success, you need to console and check the errors.

Please rate this and mark as solution/answer, if this resolved your issue
Good luck
KB

Unfortunately,  the switch resets before a factory reset can be done and the SG200 doesn’t have a console port.

it seems like hardware issue then. better request for replacement

Please rate this and mark as solution/answer, if this resolved your issue
Good luck
KB

Do you happen to know if there are jumper pins that can do a reset on the board?

sorry, i didnt tried that kind of option. also its not recommended and doing that will void the warranty.

Please rate this and mark as solution/answer, if this resolved your issue
Good luck
KB

I am unable to RMA the switch, so is there a way to “factory reset” via the onboard jumpers?

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers