Cisco SG500 802.1x - port based authentication not working

[franckehret]

Dear all,

In order to get more control on my physical ports, I'm starting to try out 802.1x with a NPS server.

I followed instructions from here https://www.youtube.com/watch?v=NIzxpHNtr7I

(Of course, not the ISE part)

I've setup:

- the NPS server policy & radius client

- the radius settings on switch

- one port with auto 

- one client with group policy

When I connect the port on client, I get only this :

%STP-W-PORTSTATUS: gi1/1/3: STP status Forwarding   

But on NPS, nothing from the switch IP (wireless works fine since years)

Any idea where I should start from ? Thx ! :-)

[franckehret · Accepted solution]

Never mind, everything was right in the configuration (GPO, switch, etc...).

The ONLY missing part was to put the Wired AutoConfig service in automatic mode in Windows... ;-)