port1 in VLAN1 natively and port1 in VLAN2

[Lukasz1977]

Hi all

I am writing about strange situation and do not know what is going on.

I have port 1 natively in VLAN1 but want to see the same port1 in VALN2 so I set it up as untagged.

When I do apply , my switch SG350-10P is getting stuck everytime.

Any syggestions ?

Thanks.

[balaji.bandi]

what is connected to Port1 ? is your device ?

[Lukasz1977]

Yes, my PC is connected to port1. But if I change all settings in switch via GUI I wolud like this port1 use as active in VLAN2 just coonect another device to be worked with others in VLAN2