Hello!According to https://www.cisco.com/c/dam/en/us/td/docs/switches/datacenter/sw/design/vpc_design/vpc_best_practices_design_guide.pdfGeneral Recommendation: ● Activate vPC peer-switch in a vPC environmentvPC peer-switch can be used in a vPC domai...
Need to know APINIC Pool Configuration for Cisco 9300 Switches
Good evening all, I am experiencing packet drops error in my network when any VC runs. I want to configure QOS in my cisco switches like as catalyst 2960 S, 2960X, 9300, 9500, etc. Help me to configure qos in mentioned devi...
Dear all,We have a Linux Radius server and in it we have two users for now for testing, user.admin and user.support, and we have two groups of users, g_admin and g_user, and in the switch I put the config below, but who is only released in g_user is ...
I need the following table of information for the IE-3100-18T2C-E switch:All open ports, the networking protocol used on them, the application protocol, the use of the port, whether it is internally exposed or externally exposed, any other notes. Por...
Hello Do you know where it is possible to find heat dissipation for the following equipment? NCS-57C1 NCS-57C3 N540X-ACC-SYS N540-24Q2C2DD-SYS
I have C9606 Switch. configure the VTP version 2 VTP domain Configure with password. and i want to see the password, and run the command Show vtp pasword but password is not showing. so how to see the c9606R Which password configure
Hi, I have a Catalyst 9300 That i configured the MSTP Root brisge to zero as main switch and other switchs from other brands ( less then 20 switchs) have only RSTP on their configuration and all defaults bridge value 32768.When i close the ring all u...
Am trying to create a new local account on a Nexus 3048 so I can SSH to it if my Radius server doesn't work. Normally, I log in with my AD account which the switch uses Radius for authentication with that. However, when I run the command to create ...
Hi we are working on migrating from juice to cisco catalyst 9300 switch is their any tool to method to deploy this??
I am attempting to recover my password from my C1200-8FP-2G that is rejecting the new password I've entered and saved. This switch has the reset button disabled so I am not able to factory reset it either. I've attempted to console to the switch and...
In packet tracer, I enabled the following command on a switchport connected to a PC.interface f0/1 spanning-tree portfast spanning-tree bpduguard enableI removed the PC and connected a new switch on that same port (f0/1). And as expected the new ...
Studying for the CCNA exam. Currently learning about PVST+ and Rapid-PVST+.I am trying to create a lab scenario for 9 PCs spread out evenly across 3 access switches. To assign IPs to the PCs, I am thinking of using a DHCP server.QUESTIONBased on best...
Can we connect 2 GSLB pair to single 9k leaf switch ?Both GSLB pair are using vlan HA vlan 100 and having different snip vlans.HA vlan 100 is L2 vlan used for heartbeat and HA .HA vlan on gslb side is untagged and used as native vlan.will there be an...
Check the following equipment: C9300-24T-AIs there a command or method (such as SNMP) to check the number of unknown unicast packets?
