Switching

Hi All, I have experienced in Cisco 9300 switch without the IP routing command, the default route is functioning but the specific static routes not functioning. But the routes are adding to the configuration and the routing table. Could you explain t...

How to get missing Visio stencils?I am getting new CISCO Components (Nexus 93180YC-FX3, 93108TC-FX3P, 9332D-GX2B, C8500-20X6C). Unfortunately, visio stencils is missing from the library.Does anyone know where I can get it from?Thank you

Hi,I have noticed that in some cases when a switch reboots, dot1x authentication fails. This goes on until I disable authentication on the port. If I enable it after some time, everything works fine.  I was thinking of adding all the mac addresses in...

Which one is fast when upgrading FEX switch? boot nxos bootflash:nxos.9.x.x.bin install all nxos bootflash:nxos.9.x.x.bin   Thank you.

Hi every oneI configured port security on some switches with different scenarios, on one switch I connect my switch port to a Yealink IP Phone Internet port, and from ip phone (PC Port) connect to a pc. switch detected 2 mac address correctly (sw por...

I wanted to check if anyone has experienced a particular bug related to executing kron policy-lists with kron occurrences on Catalyst 9300 stacks. This issue seems to occur only on stacks with more than two members. Below is the configuration I was u...

Thank you all for your support.I've encountered a strange incident, and I'm very happy to hear your advice. Two 2960 (WS-C2960S-24TS-L IOS 15.0(2)SE) are connected to each other by GigabitEthernet1/0/21. The following message was printed during syste...

I have a weird issue relating to 802.1x.  For 3 yrs now we have had 802.1x working with port set to authentication host-mode multi-auth.  Last week, our phones stopped being placed on Voice VLAN 40 & get placed on VLAN 1.  If I change the 802.1x port...

Hello Everyone!We have a parking lot switch wich is WS-C3850-48P and uplink port goes through GigaBeam LR-Ubiquity link back to the distrbution switch, I checked everything on the ubiquity link including alignment and power, including port duplex but...

Hey people!On earlier versions of IOS-XE, before 16.3.2, you could run debug pre to get debugs of control policies to see what classes were being evaluated and hit. After 16.3.2, debugs moved out of IOSd into its own Linux daemon. Now you have to use...