Switching

Discuss Catalyst brand switches with peers and experts.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Get 20% off switches when you combine Cisco solutions

 
Labels

Forum Posts

Hello Guys,   My company just buy building with Infrastsructure which is having 2 6504 E as core switches and 4506 connected with it access layer switches. all access layer switches connected with SFP ports to core switches (one port to each 6504 E s...

ITexpert by Level 3
  • 436 Views
  • 2 replies
  • 0 Helpful votes

I am trying to build a new network using a 3560G and a C3900, from the 3900 I can reach directly to the internet however after connecting the switch I cannot ping the router from the switch nor can I reach the internet..... I have posted both configs...

Folks, couple concerns regarding this new switch we recently purchased...   -Do you upgrade the firmware here the same way as you do with the lower end catalyst switches?   -if we will only use this for a single network, in our case for iSCS traffic,...

insccisco by Level 1
  • 1220 Views
  • 4 replies
  • 0 Helpful votes

Hi Guys,I'm trying configure access-list on port-channel in N7K.Ports connected to ESXi host with ~50 VMsI want to filter access for only 1 VM (with IP A.B.C.D), with no impact to other VMs.     IP access list TEST 10 permit ip X.X.X.1/32 10.A.B.C.D/...

Hello, I've found the following OSPF configuration on my N9K,     router ospf MPLS vrf MPLS router-id 10.10.255.0 default-information originate   interface Vlan106 vrf member MPLS ip address 10.10.254.2/24 ip ospf priority 110 ip router ospf MPLS are...

So if I have two redundant (primary and secondary) switches so servers can connect to each for redundancy, I am not supposed to create the same SVI ips on each switch correct (excluding management SVI which I have as X.X.X.5  and sw2 .6)? I am not qu...

Hi, Should be an easy one. Concerned about causing issues to interface settings. Came across an incorrect switch setup and want to fix causing minimum disruption. 2x Stack 3750Switch 1 = MemberSwitch 2 = MasterSo Fa1/X/X is member Switch and Fa2/X/X ...

sy_price by Level 1
  • 754 Views
  • 4 replies
  • 0 Helpful votes
Review Cisco Networking for a $25 gift card