Switching

Dear Team, Please help me to understand can Cisco ASR 1002 X can work on single AC power supply unit. Is it mandatory to provide AC power for both the AC power supplies.

Hello all,I am in the process of migrating from a core switch 4x SG500XG-8F8T in a stack, to a core switch 4x CBS350-24XTS.Now I noticed with the lags that only 8 lag groups can be created there. Previously there were 32 on the SG500XG 8F8T.I don't u...

hi, we have 4 new C9300 switches which are already stacked together and work as core switch. Now we have other 2x old C9300, and want to add them to the network. what is the best practice of below two options? option 1. upgrade the os of old C9300 to...

I was trying to send the following command to WS-C6506-E as follows,>config t>ip routingThe Switch responded with:  >Incomplete commandso,>ip routing ?  Protocol   Purge    Route>ip routing protocol ?  Purge   RouteWould you please explain what all t...

Hello. Does a 3845 with the 4 port Etherswitch HWIC support NAT across the Etherswitch ports? For example, let's say I have 2 vlans (10 and 20) and assign ports 0 and 1 on the Etherswitch card to vlan 10. Ports 2 and 3 go to vlan 20. I create Lay...

Hi,We've lost password for console access to stacked C3750x switch(4 switches stacked).Can anyone recommed me best practice(with steps) for password recovery in this case? 

I'm new to Cisco Packet Tracer and would like to configure my web server. I believe I've done everything correctly, as pinging the web server from my PC works fine. However, when I try to access the web server from a PC's web browser, I get a "Reques...

Hi Community,Tengo 2 switch C9200L-24T-4X en stack, estos son sus datos:Version IOS:Switch Ports Model SW Version SW Image Mode------ ----- ----- ---------- ---------- ----* 1 28 C9200L-24T-4X 17.03.04b CAT9K_LITE_IOSXE INSTALL2 28 C9200L-24T-4X 17.0...

Hi Community,I have a WS-C4510R+E switch, I want to update the IOS.What would be the correct procedure for updating via USB and FTP?It is a single WS-C4510R+E switch, in that scenario how long would it take for the switch to fully load with the new I...

I am experiencing an issue with my Cisco Catalyst 2960 Series PoE-48 switch. The SYST and RPS lights are both solid amber, and I'm unable to access the console. This problem began after a power outage. In the past, when this occurred, I would simply ...

Hi Experts,we would like to prioritize a subnet traffic in Nexus 7K when refering to cisco docs its very confusing generally i see with dscp and cos value not sure about the steps as they are different default templatesgenerally on routers its prety ...