Cisco SX350 show entire command output by default

[netanelp]

Hey guys,
I have an old SX350 running version 2.5.0.83.
Currently when i'm trying to output a command like show running-config I get prompted to show more of the command as it doesn't show all at once.
I am able to use the terminal datadump command to show the entire command but it doesnt save this setting by default.
Is it possible to do this by default for every login?

[marce1000]

 - Try terminal width 0 or if you don't want the confirmation yes/no then: terminal no prompt
                    I  don't think it's possible to save those , 

 M.

 M.

[netanelp]

Both of these didnt work for me, only shows part of the running config until I press space.
But not being able to save it doesnt really help I guess.

[Georg Pauwen]

Hello,

which terminal program are you using ?

[netanelp]

Well, the purpose is using Ansible to backup the config but I get the same results with putty or anything else