Solved: Port-channel switching module cisco ASR4431

opineiro1 · ‎03-25-2021

Hi.

I have a switching module NIM-ES2-8 in a ASR4431 but I can´t configure channel-group command in the interface.

The cisco ASR 4431 only can configure port-channel in the Front Panel 4 ports Gigabitethernet Module?

Reza Sharifi · ‎03-25-2021

Hi,

The cisco ASR 4431 only can configure port-channel in the Front Panel 4 ports Gigabitethernet Module?

Correct. Only the onboard interfaces support Portchannel. It should support both LACP and mode "on"

HTH

View solution in original post

Reza Sharifi · ‎03-25-2021

Hi,

The cisco ASR 4431 only can configure port-channel in the Front Panel 4 ports Gigabitethernet Module?

Correct. Only the onboard interfaces support Portchannel. It should support both LACP and mode "on"

HTH

Topsonic · ‎11-15-2024

Hi,

is there any kind of external module which supports portchannel configuration for a 4451?
Maybe the SM-X Layer 2/3 EtherSwitch Modules? As far as i can see there is a minimum of 16-port module. Any chance to get an 8-port module for the first row of 4451 back panel?

Thanks and regards

Leo Laohoo · ‎03-25-2021

Be careful of CSCvw74609.