Question of telnet or SSH to 4500X management port

[gwhuang5398]

I configured 4500X management port (Fa1) and I can ping the IP from the network. But when I tried telnet to the port, the switch showed "password required but not set".

I didn't configure any password for VTY. Should it be equivalent to "no login"? If to set or change a password for the management port, where to configure it?

Thanks a lot

[amikat · Accepted solution]

Hi,

Yes, "password" and "login" for the management port should be configured under the "vty" lines.

Best regards,

Antonin