Tag: "pri" in "Collaboration Knowledge Base" - Cisco Community

Latest Tagged

How to configure PRI circuits with a third party PBX - ( ‎06-22-2009 06:15 PM )

by on

0 Comments 2158 Views

0 Comments

2158 Views

The SIP REFER does not work correctly. When the IOS gateway receives a SIP REFER to a number, it att... - ( ‎06-22-2009 06:16 PM )

by on

0 Comments 7984 Views

0 Comments

7984 Views

PRI calls are disconnected intermittently, and calls to 1800 numbers that come over an MCI trunk hea... - ( ‎06-22-2009 06:17 PM )

by on

0 Comments 1905 Views

0 Comments

1905 Views

Calls for Mobile Voice Access through an H.323 IOS gateway do not work when Cisco MobilityManager is... - ( ‎06-22-2009 04:05 PM )

by on

0 Comments 1072 Views

0 Comments

1072 Views

Cisco Unified Communications System - ( ‎07-02-2009 02:20 AM )

by on

0 Comments 3222 Views

0 Comments

3222 Views

How to enable PCM Capture on ISR Voice GW - ( ‎11-23-2010 08:12 AM )

by on Latest post on by

2 Comments 27697 Views

2 Comments

27697 Views

How to stop a Cisco IOS gateway from sending a second dial tone with a call through ISDN PRI - ( ‎06-22-2009 04:09 PM )

by on

0 Comments 2774 Views

0 Comments

2774 Views

Unable to see the Caller Name in IPPhone for inbound calls - ( ‎12-21-2010 01:20 AM )

by on Latest post on by

2 Comments 5994 Views

2 Comments

5994 Views

MGCP Gateway Integration with CUCM and PSTN Service Provider - ( ‎01-29-2012 11:38 PM )

by on Latest post on by

12 Comments 109489 Views

12 Comments

109489 Views

Once configured with PRI, does VWIC-2MFT-T1 support ISDN data or modem calls? - ( ‎06-22-2009 04:36 PM )

by on

0 Comments 2688 Views

0 Comments

2688 Views

Top Tagged

How to troubleshoot DTMF on ISDN PRI - ( ‎07-11-2013 08:26 AM )

by on Latest post on by

5 Comments 20286 Views

5 Comments

20286 Views

Basic ISDN PRI E1 Configuration - ( ‎01-31-2013 06:38 AM )

by on Latest post on by

11 Comments 77781 Views

11 Comments

77781 Views

How to configure MGCP PRI and Gateway on CUCM 10.x ? - ( ‎06-10-2014 02:57 AM )

by on

0 Comments 13902 Views

0 Comments

13902 Views

Some of the calls placed through a PRI voice gateway (2691/3725/3745) using the DSPs of AIM-ATM-VOIC... - ( ‎06-22-2009 06:08 PM )

by on

0 Comments 1256 Views

0 Comments

1256 Views

Users are unable to issue the isdn incoming-voice voice command under D-Channel in AS5300 PRI IOS vo... - ( ‎06-22-2009 06:06 PM )

by on

0 Comments 2440 Views

0 Comments

2440 Views

With an MGCP gateway that uses the NM-HDV, the secure RTP does not work because of which of the medi... - ( ‎06-22-2009 06:05 PM )

by on

0 Comments 991 Views

0 Comments

991 Views

How to busy out the B-channel on an ISDN PRI in IOS gateways - ( ‎06-22-2009 05:39 PM )

by on Latest post on by

3 Comments 33518 Views

3 Comments

33518 Views

Configuring pri-group on slot 0 in the 2801 router generates the Insufficient resources to create pr... - ( ‎06-22-2009 05:32 PM )

by on Latest post on by

1 Comments 3748 Views

1 Comments

3748 Views

The MGCP calls receive a busy signal when the PRI Protocol Type is configured as DMS-250 - ( ‎06-22-2009 05:32 PM )

by on

0 Comments 2974 Views

0 Comments

2974 Views

Users cannot configure the PRI-group and "% No DSP resources available to configure pri-group on con... - ( ‎06-22-2009 03:33 PM )

by on

0 Comments 3730 Views

0 Comments

3730 Views

Top Taggers

User

Count