I was testing Cisco_Meeting_Server_2_9_7_vSphere-6_5.ova on both ESXi 6.5 and vSphere 7.0 U3. We noticed that the IP address of the guest OS was not being reported to the host vSphere/ESXi even though the appliance had successfully pulled a DHCP addr...
Forum Posts
I have registered an SX10 to VCS and CUCM and the OBTP does not work from either. I see the meeting on the screen next to the clock; however, when it is time to join the meeting, there is no join button.If I try moving around on the screen from Call...
Touch8 cannot start normally. EX60 screen prompts "Lost connection with control device".I just want to use the EX60 as an external monitor for my computer.Is there a way to clear the error message on the screen?Thanks!
Resolved! Cisco Collaboration
I have several Sharp Displays that I want to use with Cisco Room Bar and Cisco EQ/Quad. (3) 90 inch Sharp PN-LE90190 purchased in 2020 to be used with Cisco eq/quad (1) SHARP lc 70 le 640070 ( purchased in 2020) to be used with Room BarSharp 4TB60C ...
good community, I have an MX300 with version TC7.2.1.cb31c3d and I would like to take it to the recommended CE9.15.16.5 but it won't let me download the firmware of the previous versions because they tell me that it is "deferral notice" It also happe...
Hello there! I have a CUCM (System version 11.5.1.12900-21) with 100 extension configured. I need to create a central phonebook so that every user can access it from its phone. It is possible? How can I do it? Thanks everyone!
Recently ran into this issue where an existing custom action button/macro (zoom action panel where you put in the digits for the meeting) on an Room kit, is now only partially showing on the Touch10 (the bottom portion of the button/panel gets cut of...
Cisco has advised that when a Cisco MTR device, registered with Microsoft Admin Centre, is also registered to Cisco WebEx Control Hub, it gets the benefit of a true WebEx meeting experience whilst still on MTR mode. This statement has some firewall ...
Cisco meeting devices like Room bar and board, automatically apply Qos markings to media, video and signalling. When this device is in MTR mode, will it also mark packets based on "source ports" like Microsoft advises. Does it even apply Qos mark...
I know there are calcs for switches to calculate power. However, is there a calc that I can use for Routers, and MCS devices? I am specifically looking for AMPS/WATTS draw, Heat Diss., etc
Does anyone else feel that it would be better not to have a Preview "Share" as well as "Share In Call"?I recently had an issue where the presentation was visible in our Lecture Theatre and it LOOKED like the far end users were seeing the presentation...
I have started experiencing a content receiving issue that is happening in both Zoom and Webex on endpoints with 2 screens. Until recently everything has been stable, but as of a week ago when an endpoint joins into a meeting, if the far end starts s...
Hello all, I am using the Tandberg Quick Set C20 codec, and I need to add another camera for video conferencing, so I am wondering what the compatible cameras are.@c20 @compatibility
I am conducting a large AV project using room kit Pro with (1) quad cam and (1) P60. Everything is working great with that setup, I am using the the classroom room type in my configuration where speaker track is working with the quad cam and presente...
I need to extend 4 table mics (w/ euroblock connectors) beyond the 29' offered in the extension cable. I'm fully aware of cable impedance and voltage drop of the control wire. My question is: where do I purchase the 3.5mm male and femle pair of conne...
