TelePresence and Video Infrastructure

Dear Team,We have expressway E with single NIC deployement for B2B calls and webrtc callsexpressway E1 at DC LAN1 ( 192.X.X.X -DMZ IP) Nated with public IPexpressway E2 at DR LAN 1( 192.168.X>X-DMZ IP) Nated with public IPI have one question:Does exp...

Hi, We have 4210 Tandberg mcu with 20 ports capacity , how we can upgrade it to 40 points?Regards,

We have a Webex Room Kit Plus, we use 4 screen displays, those screens should wake up when the Room Kit is turned on but it seems to be impossible with the four screens (It works with two screens). It's there a third party accesory or Cisco which we ...

We're currently building out a 150 seat theater style auditorium / lecture style room. It will be located in a new corporate training center (non-education). We're also in the middle of switching over from S4B to Cisco/Webex so I'm fairly new to capa...

Hi, I have CTI-5310-MCU  and SX20 end-points working togetherI want to buy new end-pointWhat can be the options orderable?SX10? or what?Please help 

Hello evereone. Our organization use multilevel structure in AD. We have many Divisions. Around 30.My request LDAP Source Method from CMS to LDAP looks like: OU=Internal,OU=Users,OU=City,OU=Division_1,OU=GroupOfCompanies,DC=CompanyName (Work fine)If ...

Is it possible to send an email to IBM Notes Clients when scheduling a meeting from TMS without TMSXN from the SMTP Configuration in TMS and SMTP Configuration from the IBM Domino Side & is there any configuration guides describing how to do that (if...

Hi Guys,I was trying to order CAB-HDMI-MUL4K-9M cable for KIT plus series endpoint but could not find it Cisco CCW. I could not find any product in such name. Any idea, why its is not available in CCW?? Anyone could help...

OK CISCO ... 1.  Installed CISCO WEBEX Room 70 G2.  2. Upgraded firmware a couple weeks ago to Ce9.8.03. The system just started display a warning that the camera software is not compatible with codec ???? What is the fix please as this had been work...

Hi,We have a C20 Cisco Tandberg which has a recent strange behavior. Basically, it calls himself every ten seconds when on without visio. During a visio, the C20 disconnects every five minutes.Do you have any ideas of what is happening ?Thanks. Fabri...

Hello,    We have a few Sparkboards that we only was to use as room displays. Do we have a way to default the board to HDMI in only to displayed. 

Calls to some of our registered SX10/SX20 endpoints (usually from Zoom, but not always) end up with one-way video.  The media paths shown in xstatus are address of the far-end system.  There does not seem to be any obvious  way to get our endpoints t...

DearsI am planning to purchase a Video Endpoint webex kit plus  for B2B calls  for only 1 meeting room and a CMS with part number CTI-CMS1KM5-BUN-K9  and R-CMS-K9,,,I am  buying the SMP license in the Video endpoint configuration (CMS-SMP-EP) and als...

     We just received a Cisco CHS 435HDC set-top box from Verizon and replaced the Direct TV Set-top box that was installed. Video was displaying fine with the Direct TV box, but when we hooked everything up to the CHS box we only got a blue screen t...