I'm trying to neighbor my local VCS to an external VCS, but when configure the neighbor along with the search rule I can no longer dial the local aliases that I have preconfigured only the outlying endpoints alias.
Hello!
I know this gets brought up from time to time, but I haven't been able to find an official response (or even a hint) of what might be coming in the near future. There are numerous reports of Java support being dropped by Firefox, possibly eve...
Hello,
for a new project, my customer wants a TELEPRESENCE C60. this product is END OF LIFE. So I had asked CISCO a other product to replace the C60. CISCO recommends a SX product. My customer had already C60 in his installation.my questions:
can we...
Hi
I had a SX80 endpoint registed on cucm10.5.2, when I set the time ,language and the call procotol it worked ,but when I restart the SX80 it was return to the original position, can I save the change but not return to the original position ? Thank ...
Hi Community,
I would like to clarify, do the Expressway needs a public DNS IP address to be configured on the box to enable external calls or B2B calls?
Thanks in advance.
Sy
We are running Cisco TMS 15.2.1.
We are using a unmanaged bridge (Acano)
We have Join early enabled.
Conferences booked back-to-back utilize the same Conference Alias.
So if I have a conference scheduled from 1:00 - 1:30 it will scheduled alias 1000...
Hi All,
Recently I have encountered ISDN Link Box showing red color power indicator light steady on on the front of the box.
Currently the firmware version is IL1.1.0 working with Cisco C60 VC with firmware version TC7.3.3.
Previously it is workin...
Hi All,
Is it possible to shutdown the group-channel of E1 via CLI? ex. interface serial 0/0/0:15.1 and so on..
We are planning to test the overflow of the E1.
Our goal is, if the 30 channels are already used - it will fail over to the other E1. how...
Running TMS 13.2.2, trying to set a custom configuration setting within templates for the following setting:
xConfiguration UserInterface UserPreferences: Off
What's the easiest way to achieve that? I have 430+ endpoints(TC 7.x) and I don't want to...
Hi,
our VCS stopped working and we are trying to re-install the software using the SCP procedure.
The problem is we are getting the answer "Release Key invalid".
So we did the factory-reset command but we got a similar answer:
"Failed to initialize ...
Hello,It worked like a charm on Expressway-C/E v8.5.1, but since we upgrade to Expressway-C/E v8.5.3 (or newer, v8.6.x) to try MRA for 7800/8800/DX series endpoints, we have a problem with DTMF. Endpoints:Jabber for Android/iOS v11.1.0, IP Phone 7841...
