TelePresence and Video Infrastructure

Hello. We have configured routing on network. When video goes through a router video quality deteriorates (when we configured the router ISR as  gateway for Cisco IP Phones 9951). But when we configure the Switch 6807 as default gateway for IP Phones...

Hi Cisco,How to factory reset C40?The problem is that someone accidentally disabled the infrared between the codec and the remote control.How to re enable back the infrared so that we can access the C40 menu options again?Thanks

Hi, We are looking at getting our VCS appliances virtualised and in the process of doing this we are also doing some shifting / decommissioning of these VCSs in regards to where they sit within our network and in doing so we have found we have no re...

On the Cisco SX10 Quickset unit, it can operate fine without an external microphone.  It has one built into the all-in-one unit.  However if the CTS-QSC20-MIC (External Microphone) is hooked up, does the built-in microphone continue to work as a seco...

Presentation issue I have Tandberg 3000 mxp device in of my site. I Codec end a DVI cable mail  with 02 nos of RCA connector is connected.  02 nos. of  RCA connector are connected to port 5 and 6. Other end a VGA cable mail  with Audio connector is c...

Hi,What are the replacement of the below Tandberg VCSContent server Managment Server Thank you

Hi Experts, I have proplem with creat a Account for my customer only login and change password for a user Jabber, how do i do? Many thanks!

Hi Team, Recently we have deployed one IX-5200 18 seat. We are facing few issues.After registering and integrating the device. 1. 1st 2nd Row Touch panel is not showing green light indicator for all 6 touch panel & not able to increase/Decrease the...

Is it possible to lock a conference so that new users cannot join after 10 mins of the scheduled conference start time.  Conference is hosted in MCU registered to VCS control.  TMS is used for scheduling the conference.  Is the same config possible f...

1. Is it possible to just use the Speakertrack mics in the backpanel for VC calls     and camera tracking without the need for any tabletop microphones at all? 2. We are currently using Cisco VC unit with 3rd party microphones and would like     to...

I am trying to register  MX 300 via Expressway E. i found this issue status=Failed&host=hostname of expressway e &reason=GET Edge config: Peer certificate cannot be authenticated with given CA certificate Type ProvisioningStatus I hav...

Both fans 1 and 2 are showing they are locked on 4320 rpm. We have never seen this with our other C20's. The software version is TC6.0.1.65adebe. Should there be a concern?