TelePresence and Video Infrastructure

HiIs it possible to get a snapshot from a C40 system using SSH or wget ?we are making some major changes in our lab and I have a C40 system that i want to set up in our Lab to film the progress of the renovationsthe idea is to grab 1 frame every 20se...

Hello Team,I have seen ISDN gateway with auto attendant feature . User has to dial the number and enter the alias to get connected.My questionWe have a VCS Expressway which is exposed to internet for video calling .  Does Cisco has any such solution ...

Dear Team, I have a SX20 & i have done downgrade version without release key & also done factory reset but error release key is showing till. my query is here that any option is here for assign to IP address Subnet & gateway address because i m tryin...

 Hello I am bk...Now I try  webrtc communicate with sx20.    I send invite message include  SRTP SDP. but sx20 answer normal RTP SDP.  anyone know why?webrtc show "NO-DTLS ERROR, NEED FINGERPRINT" sx20 is not support fingerprint? please help me.send ...

Dear All, i already install codec c60. when i try to share a presentation, i should use the remote and select presentation > pc.because the default is no presentation. can i change the presentation to pc as default? Thx,Anju

Hi allI have the follow situation:- Jabber for Windows 9.7 (allowed to make Video and Audio Call)- CUCM 9.1.2- Software Audio Conference Bridge available/configured- Codian MCU 4.4 registered on the CUCM as Video Conference bridgeProblem:If I make an...

 Hello I am bk.I  upgrade my sx20 to  version 7.1,   command  :  systemtools rootsettings on <password>  show error....!how to setting root password...  or how to make userid....   I need make tcpdump.... 

Does cisco has a roadmap where presentation from a laptop can be shared via Wifi 

I have an MX300 which I'm trying to upgrade from 7.0.1 to 7.0.2 via TMS.  I've upgraded one other MX300 and a number of MX200's using the same image withour any issues.  When I try the upgrade via TMS I get the following error: The event failed to co...

Anybody have documentation or configuration guide that states FIPS should be disabled in Windows 2008?  I've seen documentation that implies MXPs are not supported, but nothing definitive.  Can anybody point to documentation validating the following ...

Hi All,  We recently updated to TC7 and are taking a look at the new diagnostic tabs. I see 0% packet loss consistantly on the majority of the calls but I see a large variance in the Max Jitter numbers everywhere from 4 to 63. I was wondering what do...

Hello,  I have CUCM - > VCS - > VCS Express deployment. Some endpoints are registered to CUCM and others are registered to VCS.I have prepared the prerequisites, so please correct me if I am wrong.VCS:Private IP Address, subnet mask, and gateway.Loca...

How to configure FXO/FXS port on 3800 series router for analog fax machine use?  I am using VIC2 -4fxo & VIC3-4fxs.How would I configure the  ports to support this and also the dial peer? Thanks for any help/examples.  Regards,Ajay Jose K  

I fornd a tread that talked to integrating an older Call Manager 4.x with an older Polycom RMX.I am looking for some guidance in answering if I can use an RMX2000 as a Video/audio MCU for doing video conferencing between a bunch of cisco phones with ...

I upgraded from X.7.1.1 to X.8.1.1. I no longer get video or audio across traversal.  everything works internal.  Video/Audio also works if registered to the expressway calling outside of network.  It is only traversal link.  I have asked them to con...