TelePresence and Video Infrastructure

Hey folks, I have posted this in the switching community in the SB area but thought I might have more success here. https://supportforums.cisco.com/thread/2236673I got two new switches (SG200- 26 Gb) to replace a single unmanaged one. This problem oc...

Hi,i have mix Endpoints,immersive(TP 3000) and non immersive(C Series).Can i use IPVCR for recording?What is recommended Recording solution?RegardsSaad

EX90 Registered to Regional CUCM :: Not able to dial out of history to external endpointsLab deployment;Cisco VCSe - 7.2.2Cisco VCSc - 7.2.2Cisco CUCM (SME Cluster) - 9.1.1Cisco CUCM (Region_B Cluster) - 9.1.1Endpoints;Movi - 4.6 - Registered to Cisc...

Sharing presentation from Jabber windows does not show up on CTS endpoints. following is the call flowCTS-->CUCM<TLS Trunk>VCS<--Jabberif the trunk is reverted back to TCP, presentation works.This happens only to Jabber. Other endpoint such as C and ...

Dear All,Currently, we are trying to mak video call from 9971 to asterik ip phone.i already configure the sip trunk and pattern.it works for voice call only, but no video.Need help. Any idea?Thank youAnju

At what value of memory usage does the mcs 7845 trigger critical alarm?

dears,i have ONLY a c60 unit and i want to make a public calls( internet) ,, i have a local ip adress and its nated to a public ip adress please advise on how to do the set-up

I have an SX20 quick set operating on software version TC6.2.0.We have had some issues with H.323.  Are any of you aware of any stability issues or known caveats that would warrant upgrading to 6.2.1?                  

Hello Everyone!I need consultation about configuration VCS Starter Pack that will help against SIP scanners..Looks what we have:  VCS with public IP, 4 SX20 also with Publick IP in different cities(If it needed we could hide them behind NAT) and some...

In the Multiway deployment guide the procedure is shown to activate Multiway for Cisco Jabber for Video  endpoints by adjsuting the Jabber template on TMS (use with TMSPE) with the parameter: "Multiway Participant URI" = {username}.meet@<SIP domain> ...

Hello     I am trying to find out how to change the admin password in TMS for a MSE8000 we have added.  If we change it on the MCU first and then go into TMS, TMS ends up locking the account because it tries to access it too fast using the old creden...