TelePresence and Video Infrastructure

Hi,our customer asked if it's possible to NAT TMS's own IP address. A NAT separates TMS and endpoints, but they cannot do one-to-one NAT on endpoints. So the only option would be to NAT TMS itself, but I cannot find information on Administration Guid...

Hi expert, I usely install endpoint visio like C-seris with a touch control, and usely the administrator ask, how to prohibit access to the administrator section in the touch control but I don't fine any solution in documentation of touch control, i...

Hi,I´ve registrated a Polycom HDX-Endpoint via SIP on VCS and added it to TMS successfully. If i want to book the endpoint via TMS or TMSXE, I get an error, that there is no route beetween the Polycom and Cisco Endpoint.I´ve seen, that TMS doesn´t ge...

Hi,I'm trying to configure a touch panel associate to CTS-1300. I want to have the "Directory" tab on the panel to add local contact. I've followed that document, but the tab doesn't appear:http://www.cisco.com/en/US/docs/telepresence/cucm_cts/cucm_c...

This could be a stupid question, but it has confused me quite a bit. I have a layer 2 switch that has the "mls qos trust cos" statement on an access port. I have a device that marks DSCP values as EF, or the ability to mark as TOS. Layer 3 markings.T...

When doing a call to another Cisco C40, I had recentlybeen given a layout option which included a large window on the left part of the screen showing shared content, and tiled video windows on the right side of the screen moving vertically, as below ...

Hi everybody !I meet registration problem on a   VCS Control (7.1) with a terminal (TC 5.1.4). I made the configuration normally but I have this error message bellow :I tryed to change the policy in the subzone of terminal like "treat as authenticate...

                  I would like to know if it's possible to limit the ability of codec C20 (TC5.1.6) to make an audio call when a video call is already active.  I tried to put "Multipoint Mode" option to "off" but without success.  The C20 is still ab...

Anyone else having an issue with the fact that with TMSPE you now have to buy findme if you want properly working phonebooks?I ran into this when creating a new instance of TMS with TMSPE. With out findme the phonebooks do not work properly. They are...

Hi,Just looking to get some feedback from other users on which codecs you have enabled on your MCUs in a multi-vendor environment, we've had some issues recently so we've locked it down to the below, I appreciate there probably isn't a 'safe' configu...

Hello!Can you please help me - I try to interop VCS-C and CUCM following Cisco_VCS_Cisco_Unified_Communications_Manager_Deployment_Guide_CUCM_6-1_7_8_and_X7-0.pdf but it not works in both ways. When I try to locate CUCM nomber (77xxxx) on VCS-C, it t...

Hi team,a customer is using a lot of Transforms in VCS-C (X7.2) to reduce manual faulty dialing from endpoints and to force communication via SIP protocol.So for each new Cisco VC-EP (Profile and EX-Series) customer creates two new Transforms.(It's a...