Hi all,Does anyone know if it is possible to change/adjust VCS's operating system time manually?We want to do that without NTP server and no TImezone setting.Best Regards,Kotaro Hashimoto
HelloI am new in Telepresence, and Is erach for any material that help me to design a Telepresence solution, but I faild to find a valid one. I need to know what is the Telepresence infrastructure and why should we intgegrate with CUCM?, What is the ...
Hello everyone,Recently we made a change to vcs over the network and lost network connectivity ... I have the box physically in front of me .... How should I go around changing the IP address ???Should I console into it ?. If so; what will be the com...
Dear Support Community,As you can see on the screenshot the problem with the german version of the scheduler is that the time is wrong shown, after 12:45 it shows 1:00 instead of 13:00, are you aware of this issue?kind regardschristian
HI all,On MCU software version 4.3(2.32), "Video receive bit rate optimization" and "Flow control on video errors" are automatically enabled, when MCU is in one of the HD, HD+, or Full HD modes.But our customer needs to disable "Video receive bit rat...
Hi Everyone,we have a video infrstructure in which there is a1)VCS control verX7.12)VCS expressway ver X7.13)TMS 13.2we have recently upgrated tms 13.1 to 13.2 and installed TMS provisioning extension on TMSAfter installation of provisioning extensio...
Hi,On the TC5.1 Touch Screen for C20 or EX90, is there a way to disable acces to the "Language, Camera Control & Setttings, Display Settings and Ringtone & Sound Settings"?This to avoid any problem of mis use by customers.I don't find any command in ...
I'm looking for a doc, presentation or other information that is essentially the equivilant of the CTMS documentation on room/speaker switching. I am trying to understand the correct behavior for how CTS rooms will behave in a Multi-point call using ...
Hi All,I'm having trouble upgrading two of seven c20s that we have from 4.x to 5.x. I started the upgrade process in TMS and five of the seven systems upgraded with no problem. Two of them were postponed several times because TMS said that it could...
Hello!I've looked but haven't found any way to see if the touchpanel for a system is connected, exept looking at it directly.I need ro verify this remotly. For example via SSH/Telnet, or the gui.Is there any command that gives this information?
Dear All i have c 90 with 2 Cisco external Camera. i intigrate with AMX. this is a student setup . when student press PUSH Button Camera preset call. i face some problem during this .1) when student press PUSH button All Camera Call prese...
The TMSPE Installation installed successfully, or so the log says. However when the TMSPE service is started, this error shows up in the log and the service will not start.STATUS | wrapper | 2012/08/01 07:22:03 | --> Wrapper Started as ServiceSTATU...
followed several people's posts about how they've successfully registered an E20 to Call Manager.So far no luck. I’m getting a Reason: 485 Ambiguous – device type not recognized.I’ve also tried to reset to factory default with the ** (presentation ke...
Dear ExpertMy VCSE all the sudden cannot working.I have try the following but I still can get VCSE1) I able to ping it, but cannot access it on by web admin. It can't find it by web either by https or http.2) I try to telent it. I able see the "Login...
