SX-20 stand alone

[ra 011]

dear all 

i have SX-20 and want to use it as  a stand alone and want to know how the jabber client that is registered with  my call manager will call  it and  how  it will call my jabber client  ? and there is no sip proxy if it will register sip  and what is the configuration needed if  i want to register  it with  H323 ?

[George Thomas]

You will have to register SX20 to CUCM for Jabber to be able to SX20. It will register as a SX20 (its a device type under Devices -> Phones) and once you give the SX20 a extension, Jabber will be able to call this extension.

[ra 011]

SX 20 will not register to CUCM  , it will work as  a stand alone , i want  to know  if it can dial a jabber client and what is   the configuration needed  ?

[Jonathan Schulenberg]

Not going to happen, at least not with a significant and unnecessary middleman of Expressway. Jabber does not support direct IP dialing. Far easier to register the SX20 to CUCM as George suggested.