cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
636
Views
0
Helpful
2
Replies

Touch Pad on EX60/90

stanley.april
Beginner
Beginner

WIth the latest software upgrade to TC 5.1.3 I have a locations where their network is retricted to one MAC address per port. Since the software upgrade the EX60/90 is broadcasting two MAC addresses per port; one for the codec and one for the touch panel. Is there a software change to prevent the touch panel MAC address from being broadcasted?

1 ACCEPTED SOLUTION

Accepted Solutions

Danny De Ridder
Cisco Employee
Cisco Employee

Hello,

I think you are running into following ddts :

http://tools.cisco.com/Support/BugToolKit/search/getBugDetails.do?method=fetchBugDetails&bugId=CSCtz86298

Will be fixed in TE/TC release 6.0.0. Is not backported to TC5 release(s). Perhaps that should be done, the backporting?

View solution in original post

2 REPLIES 2

Danny De Ridder
Cisco Employee
Cisco Employee

Hello,

I think you are running into following ddts :

http://tools.cisco.com/Support/BugToolKit/search/getBugDetails.do?method=fetchBugDetails&bugId=CSCtz86298

Will be fixed in TE/TC release 6.0.0. Is not backported to TC5 release(s). Perhaps that should be done, the backporting?

Thanks for your prompt response.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: