Touch Pad on EX60/90

[stanley.april]

WIth the latest software upgrade to TC 5.1.3 I have a locations where their network is retricted to one MAC address per port. Since the software upgrade the EX60/90 is broadcasting two MAC addresses per port; one for the codec and one for the touch panel. Is there a software change to prevent the touch panel MAC address from being broadcasted?

[Danny De Ridder · Accepted solution]

Hello,

I think you are running into following ddts :

http://tools.cisco.com/Support/BugToolKit/search/getBugDetails.do?method=fetchBugDetails&bugId=CSCtz86298

Will be fixed in TE/TC release 6.0.0. Is not backported to TC5 release(s). Perhaps that should be done, the backporting?

[stanley.april]

Thanks for your prompt response.