Hello, I have problem with incoming calls from ITSP, the calls rings out on CIPC but answering makes no sense on calling cell phone.here is TranlatorX flow, router's config and debug ccsip message output.! voice service voip allow-connections h323 t...
I'm looking to use the voice class server-group command in a CUBE config, and looks like we can only use ipv4 or ipv6 as an address type. Any way I might be able use a DNS name instead? Doesn't look like it. I suppose I could translate it to IP, but ...
I'm trying to record a message on the phone through CUTI, then set it as a greeting using CUPI.When I record, I POST{"op":"RECORD"}to /vmrest/calls/{callId}, which returns the following once I finish recording by pressing # on the called phone{"op":"...
Hi Community, I have a doubt Staff that administers the active directory (LDAP), tells me to make some changes in the parameters of organization units (OU), the service is configured in such a way that users use authentication through LDAP. My questi...
Looking to install Jabber manually without UDS for testing.I've looked at some documentation but it only speaks to how to setup UDS but not how to setup and install Jabber without UDS. Just want to enter the information manually or a config file.any...
Can we restore a DRS Backup of CUCM 11.5 on a new CUCM 12.5.1 and vice versa from CUCM 12.5.1 to CUCM 11.5 ?
Hello, We had to do a disaster recovery for the Unity 9x after that we started having the following log errors. Service operational status is DOWN. Connection Access Layer;Connection Diagnostic Portal Service;Connection Directory Feeder;Connection In...
Hi all, We have an IM&P cluster of 2 members in Active-Standby mode. VMs installed with 5k ova. Users increased and we need to go to 10k. Question is do we need to install new VMs with 10k ova or we can just increase vCPU, vRAM and vDisc to the numbe...
Hi! I would like to know further about the port ranges that is required deployment of UC infra.For example:expressway guide, port range 1024-65535 need to open. does this mean you need to open all these ports? or you can select any port number from ...
I was hoping to get some help with this. My boss and I are admittedly completely out of our depth with this Cisco phone cluster. Yesterday our CUCX sub virtual machine powered down for unknown reasons. After I got it back up, I have this inconsistenc...
Hello community, I have encountered a problem while trying to upgrade CUCM version 11.5.1.13901-3 to version 12.5.1.15900-66.I wanted to run the pre-upgrade tests first, but it appears that the pre and post-upgrade files are not recognized by the sys...
Hello colleagues! I've got an issue with DRS system which doesn't want to work correctly. During the backup procedure the Master Agent sometimes get stuck at TFTP stage or can't even connect to subscriber showing Status: Local Agent is not respondi...
Hi I am searching for solution or service to forward the local calls from each country to our MS Teams. Appreciate your help Thanks
Hi Experts, From the OVA document below, CUCM 12.5 can be installed on ESXi 6.5 and 6.7 and uses "CentOS 7 (64-bit)".https://www.cisco.com/c/dam/en/us/td/docs/voice_ip_comm/uc_system/virtualization/virtualization-cisco-unified-communications-manager....
Hi, We would like to build a relatively simple IVR based on Unity Connection.The worker calls the CUC number , and make an outside user system transfer (authenticated with UserID and PIN ) to a mobile or PSTN number.As we need to record all the calls...
.jpg "VIP Expert"){kind=icon}
