Dear Team, Our customer reported an issue. Call forward not working. When a user press cfwdall softkey, the phone immediately responds with "call cannot be completed" IVR. The phone is not allowed to enter even a single digit. at the same time call...
Forum Posts
Hi Everyone.Hope you all are doing well.I was just learning about SIP Normalization Script in my Lab Environment . I have two phone with extension 6001 and 6002 . I want to manipulate FROM header , where if i call from 6002 , it should show 60225588...
Dear everyone,I need to install 53 locales to our Call Managers. I created the ISO file contains 53 locale installers and tried to install from CUCM OS Administration. However, I can only install one by one locale installer and it takes me a lot of t...
We are getting an intermittent problem where the first number of the voice mail pilot is being put and the end. The vm pilot is 9358995. When certain users press the vm button on the phone, it is dialing 3589959. Sometimes we can reset the phone a...
Resolved! To test the failover of sip trunk
We are planning to test the failover of sip trunk by shutting down the primary interface to check if the calls are routing through the secondary sip trunk. I hope there is a configuration in cucm where we can choose the primary and secondary sip trun...
Hi, I am getting the LogPartitionHighWaterMarkExceeded alert from RTMT and i have tried to purge the logs by setting LWM to 20% and HWM to 25%. Then I've waited for 1 week with the above mentioned % and set back to the default value after one week. I...
I've got a 10.5(2) UCXN cluster that the customer wants to upgrade to 11.5(1)-23900. Off line upgrade of the pub went perfectly. Started off line of the subscriber, and it cannot seem to start. In pulling the logs, it appears to be failing becaus...
Hello all, I am trying to configure SNMP on PCD 11.5.1. I am using the below commands on CLI (no GUI for that on PCD) utils snmp config 1/2c community-string add utils snmp config 1/2c trap add utils snmp config 3 user add utils snmp config 3 trap ad...
Hi, We just install our collaboration infrastructure (CUCM and CUC) and find out that forwarded call by IVR from PSTN is not getting ringback tone (just dead air). Our call flow is like this: PSTN --> FXO Cisco4351 --> CUCM --> CUC --> IP Phone The I...
Multiple users affected in incomingPlease help find me me steps and bugs to use Newcomer one...
Our phones have been getting calls from @ constantly. I know there is definitely more I can do with the firewall (firepower) and am open to any suggestions, but I was wondering about the Voicemail CSS and partition in CUCM and how that needs to be co...
Hi everyone, I have Skype for Business connected to CUCM via SIP trunk, all works fine, My question is : is direct video call from SfB to SIP phone (9971) is possible on this SIP trunk, in theory or have anyone configured it.I couldn't really figure ...
Hi, If anyone has good documentation on Policy Decision Point (PDP) please share. I saw below the Syslog message on CUCM and just want to more about this. %UC_CALLMANAGER-3-ConnectionFailureToPDP: % [PolicyDecisionPoint=https://CiscoCMS:445/RPC2/] [...
Hi, Is there any cisco call manager simulator or CiscoUCM simulator where we can test the Cisco apis? RegardsSumantha
Hi We have a CUCM cluster (1 pub, 3 subs) in v12.5.1. We have a plan to start installing parches and updates for this cluster. We were able to install a security patch without problems. Then, we tried to install update SU6, but the upgrade failed af...
