Resolved! Cisco UCS Unified Ports
I am trying to converts ports from Ethernet to FC on UCS but the slider is starting from left to right instead of right to left. Is this the new firmware?.
Forum Posts
Have a pair of FI's in IMM mode running 4.2(2c) firmware. Trying to figure out which server firmware bundle to run on B200 M6 blades? The FI's are not listed in the interoperability matrix. There doesn't seem to be a definitive answer on how to deter...
Good day, I'm having an issue where the UCS S3260 will not allow me to create a VD from the Storage configuration on the CIMC I have tried assigning the Disks to the correct Zoning policy in multiple ways and every time I go to the Storage > Raid Co...
This is a newly set up C220 with a new CPU, memory, and drives. the server blinked the power LED orange one time, and the identification LED blue when plugged in. I have tried reseating all of the drives, memory, fans, and power supplies. I took a po...
Dear Experts,As title, I have question about CIMC of server after it associated to UCSM, Is it possible access CIMC ?And in my case, I can not see any IP of CIMC in UCSM.(I am using UCS C series , UCSM v4.3)Thank you in advance !
Resolved! Fabric Interconnect add vlan cli
HI have a Fabric Interconnect version 3.1(2b) and I would like to add a vlan via cli, how can I do this task. Thanks.
Resolved! How Can Cisco FI discovery Server
Hello Experts, I am searching aboout cisco Fabric interconnect to UCS server, I am wondering how can Cisco FI discovery UCS Server ? Can you help share some explanation ? Thanks in advance !
This is a newly set up C220 with a new CPU, memory and drives. The server was running great for about a week. Then we started to do some setup things with ESXi and that's when the server shut off unexpectedly. After that the only thing the server doe...
Hi, I am only able to locate host utility iso and that does not have bios and cimc/imc files. Where can I download bios and other firmware files to manually upgrade? Thanks
Resolved! Set P-SATA via Powertools?
Trying to automate the creation of BIOS policies in our environment, I've been able to set everything via powertools with the exception of setting P-SATA to AHCI. Anyone know if among the dozens of Set-UcsBois commandlets there is a way to enable tha...
Can we use a higher B bundle than A within the same release. For example 4.2(3e) with the 4.2(3h) B bundle? I am sure we can but I cannot find anything specific. Thanks.
Can someone help me in locating the serial number of an SD card in a Cisco UCS Server (UCSB-B200-M4)? I am aware that there are two SD cards in a UCS server, and although I can obtain the serial numbers of both SD cards in Cisco CCW-R, I cannot find ...
Hi Community, I have a UCS Servers with Fabric Interconnect and I'm doing troubleshooting because I see CRC errors on several IOM ports, I ran the command # show platform fwm info asic-errors 0 to determinate the cause of those errors, in the field D...
I created this advisory because there is no central public Cisco Advisory page with all the information users would want (yet).https://www.reddit.com/r/CiscoUCS/comments/160scwg/cisco_ucs_m5m6_downfall_cve202240982_advisory/I will expand it as I get ...
Can I repurpose the UCS M5 server? It is being used as a DNAC right now. Is it possible to remove DNAC and install ISE instead?
