Hello everyone. When creating a RAID 6 array on a C210 M2 equipped with an LSI 9261-8i HBA, is it possible to select which physical hard drives you want to be used for parity?
Many thanks!
Is it possible to have servers connect by FCoE to nexus 5000 switches as well as native FC attached disk arrays and tape librarys without requiring an additional FC switch like the MDS 9000? The reason I ask is that all the diagrams I have seen on co...
Hi,
A recent vulnerability scan has shown a SSH/Dropbear server vulnerability on UCS Managed C240M servers.
Cisco Bug ID CSCvb56137 details the issue.
The C240M servers are managed via UCSM. UCSM was recently upgraded to V3.1.2E along with all Blades...
Hello Guys,
Need you expert comments on one of the doubt i have came across.
This is regarding out-of-band (OOB) IPv4 address assigned directly to the Blade server
or IPv4 address assigned thro service profile from global ext-mgmt pool.
My question...
We are in process of replacing motherboard of our UCS C220 M4 server.
The RMA we ordered came without the Thermal Paste UCS-CPU-GREASE3.
We are supposed to purchase the same from market.
Now the question is which color cap thermal past should we use...
I've noticed Cisco offers a replacement rack ear kit for the C220-M4s, but havent been able to find anything on the C240 stuff.
The 24bay M4SX has the console port on the right side ear. Any ideas?
Cheers!
Hello!
My setup is:
Cisco UCS with 2x UCS-FI-6296UP (running 2.2(8f)A), each has 2 ports configured as channeled trunk ports, for the vlans of the vms running on some blades. The trunk ports are connected to a Nexus 5596UP.
Is it possible to query th...
Hi guys, I have added this CNA to the UCS server and drom CIMC I only see it as a PCI device, not a network adapter. I need to see it as a network adapter so I can configure VNIC on it. How do I ensure CIMC sees it as a network adapter?
Our 2 FIs are 6296UPs with fully-populated expansion slots, 8 chassis (8 x 10Gigabit fiber optic cables per side per chassis), FC to our VMAX SAN (no blades have any local storage).We have 28 x B200 M4s, and 18 x B420 M3s, leaving only a couple of fu...
[Solutions] Windows 10 Won't Install/Boot from USB ISO - Error Code 0x80070570
. Possibly you didn't get a decent duplicate of the Windows 10 ISO record, which will bring about blunder code 0x80070570.
2. Have no clue about how to introduce Windows 1...
Now we have 3 esxi on hyperflex enviroment.
as we don't have DNS server . all hostname of ESXi named localhost
as to log , we set up as follows.
"esxcli system syslog config set --loghost='udp://vcenter-ip' "
No DNS enviroment coused esxi to send l...
Hi,
I have recently started seeing this message within our UCS enviorment.
XXXXXX00-A# show faultSeverity Code Last Transition Time ID Description--------- -------- ------------------------ -------- -----------Major F0885 2015-1...
Hey all,
Any input would be appreciated with this one. I'm wondering if it's just a major hardware failure that is causing the Bios to not finish post or if its possibly a firmware bug.
Please see the attached.
Thank you for your time!
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:
