Unified Computing System Discussions

Hi Everyone, The support forums have been a great help wanted to thank everyone for their input. I'm upgrading to 2.2(6) from 2.2(3d) and during the auto install I'm getting stuck at 65% on my Fabric Interconnect. I Tried to force it with manually b...

Dear expert, I have installed UCSC-RAID-MZ-240= RAID into ucs-c-240M3 server.I have disabled  embedded RAID card from bios. During installation of wind2k12 server I can't find driver for RAID card.I have tried several driver but it is not working. I...

Sooooooo, I believe I am at least part-way to having this configured properly. I've zoned, assigned storage, configured boot from san on the UCS. I installed vmware by mounting the CD image, booting from that, installing from my SAN LUN. Did a touch...

Hello, Looking for a link to that shows how to add a member to a zone Thanks in advance.  All replies rated

Hello Friends, There are need to configure port connectivity between Cisco FI 6248 FC port & Broade SAN switch. So can I create port channel between them. So will get redundancy as well as more bandwidth. As this configuration will going to do first ...

Good overview of 3. Generation hardware and UCS version 3.1. Release http://ucsguru.com/2016/02/02/cisco-ucs-generation-3-first-look/

Hi Experts: I have a UCS managed C460-M4 and I would like to REDUCE SPOF for my Management Network [KVM Console] which is currently limited to Slot 4 with my Cisco VIC.Firmware is 2.2(5b). Q1. How to achieve it if VIC in Slot 4 has hardware issues ...

Hi,I decided to upgrade UCS from version 2.0.1q to fresh and new 2.0.5c (on 6120XP).After I had disabled calling home, I activated the new version of UCSM (adapters, CIMC will be updated using a host fw pkg later).And some nasty thing started to happ...

Hello I'm facing the following situation with a UCS infrastructure : when shutting down FI - A  uplink , all vNICs  fail over to the second FI B. At most one ping is lost. When re-enabling the uplink , the failback  occurs but I loose almost more tha...

In a B series UCS , sitting on FI A ( Primary ) management interface console , can we reboot FI B . If so how ? I need to know the command. Can FI be able to reboot from UCSM ? Again, if it is possible , how to do that.