Unified Computing System Discussions

Dear Techies,I have received the following requirement from one of our customers.********************************************************************************************************************Required Blade Server as per following specs:Location...

Oracle RAC uses Service name rather than SID and Oracle adpater only accepts a URL string in sid format.  How can a connection be defined for a RAC environment? 

Hi,I'm new to UCS, so would appreciate some guidance on connecting a Fabric Interconnect cluster to a pair of N7K's. I understand the benefits of running in end host mode, but need to confirm what the best routing solution for the UCS VLANS would be....

This is an opportunity to learn and ask questions about utilizing Cisco data center technology and integrated solutions with subject matter expert Ramses Smeyers. Additionally, Ramses will answer questions about FlexPOD, vBlock, Unified Computing Sys...

Hi :I want to install in UCS-C220M3 above the ACS 5.5 system, but as an error message attachments regardless of how the installation will occur; ask who can help me; thank you! Hardware Specifications : CPU E5-2620 * 2RAM 8G * 2HDD 300G * 3RAID CARD ...

hi all, I have cisco UCS C240 M3 with 4 HDD*600 G I tried to boot it and after adapting its RAID and configured CIMC and rebooted it I found that log appeared: " media test failure check cable " please advise. 

I do not see 5.5 U2 listed in the hw/sw interoperability matrix.  I have 6248's 2.2 (1d) with B440 m2 & B200 m3. I am assuming I would not be supported at this fw level.  Is a certified fw level coming soon? As well as a "cisco esxi 5.5 u2" .iso buil...

Hi,  Recently we had a hard disk replacement on one of the customer's C-series servers. Two days after it, the customer had experienced the said serve disconnecting from the VCenter - and hanging upon rebooting. They have done a cold boot since and t...

1st step, racked server, added power..blah blah... I goto into F8 and setup the IP (disable DHCP) for the CIMC interface. I also set a password for admin to login. Now I can PING the interface and I can even SSH into the CIMC and login as admin (but ...

Hi,  I've UCS with 2 Fabric interconnect, today one of FI not working and from Console its boot but not respond to Ctrl+J or Crtl+Shft+R then Hung on "Loader>" ?  Any suggest Please