Unified Computing System Discussions

As my another discussion suggested, I have VIC 1240 and 1280 adapters installed on the B200 M3 blade.Automatically UCS will create 4x20G port-channels between the adapter and the blades. So we have 80 G total b/w to the FI from the blade. 40 G to sid...

HiI have this issue that I got the error code F0864.I have read that the workaround is to unplug the IO module and plug it in again and then do an reset (reboot) of the IO module!?I wonder if I can do this without any interrupt to the environment ?I ...

i am looking at the port channels configured on the FI. And this is it. port channel 21 is (eth 1/27-20) which is connected to the nexus 7000so what are the rest? (nxos)# sh port-channel summary Flags:  D - Down        P - Up in port-channel (members...

Hi team,Have to quickly configure the UCS to provide 80G link from B200 M3 blades to FI.I have two adpaters: 1 VIC 1240 (VIC1240 is in the mLOM slot), 1 VIC 1280 and IOM module is 2208xp. After tchecked the doc, I found the solution as attached. But ...

We just bought and installed some B200 M3's.  We also purchased the SD Cards so that we could install ESXi on them.  We cannot see how to get the SD Cards to show up as a Local Disk option in the M3 servers...Any help would be appreciated.David

Dear Team,We were trying to create  port channel between UCS FI and MDS 9124 But the port channel not getting active in F mode on MDS 9124 FI is in FC End Host Mode We have enabled FC uplink trunking on FIWe have enabled NPIV on MDSWe have enabled...

Just got my hands on a few C240 M3′s with the VIC 1225 adapter and began setting them up as a VMware 5.1 U1 cluster. I’ve configured 8 vNICs per host: 2 for Management, 2 for VMotion, 2 for iSCSI, and 2 for VM traffic. Each pair of vNICs has one pinn...

I am trying to obtain the list of Server Ports that have been enabled on the FI-s using PowertoolI am using the below command and I am not getting nadaGet-UcsFabricServerCloud -Id "A"  | Get-UcsServerPort -AdminState "enabled"Have tried without any a...