Unified Computing System Discussions

Hi All,I have a case which S6100 have some 10G ports error, now I want to run the traffic test with the IXIA.I boot the system with N5K image and create 20 vlans(2 ports in a vlan), but I cannot diable the spanning-tree for the test.So if anyone have...

Is there a way to customze the numbers that get appended a Service profile either at creation or after the fact?

Setup -We have a NetApp SAN FAS 3210 controller with 10 G fcoe ( UTA - unified target adaters) ports available ( in addition to the FC ports which we are not using ). When these 10 G fcoe UTA are connected to the Nexus 5k ( 5548) over twinax cable , ...

Can a Storage array either FCoE capable or native FC be directly connected to the corresponding ports on a UCS Fabric Interconnect 6100/6200?If yes are there any limitations and would answers to both the above questions hold true even when we are spe...

Hi,I was reading over the Microsoft SharePoint 2010 on Flexpod for VMware (http://www.cisco.com/en/US/docs/solutions/Enterprise/Data_Center/App_Networking/SharePoint_FlexPod.html) and noticed that they had Microsoft Clustering configured, but it didn...

HiHere is the Scenario and Problem of our issue.Scenario: 2 x Cisco UCS 6120 XP Fabric Interconnects connected to the 10 GbE ports on the FCX-648 E. The ports on the Cisco UCS are configured as trunk ports. The 10 GbE ports on the Brocade switch are ...

Looking for some information on UCS vs. other solutions.  I am looking at IBM System Director and it seems that I can manage some storage devices through its support of Storage Management Initiative.  And I wonder if the same functionality exists in ...

Hi,What happens if the global profile for the vSAN ID changes?  We added two blades to our UCS and when we tried to map storage to the vHBA's we found that the would not connect.  Further research found that the global vSAN had some how changed and I...

Hi ForumAfter upgrading to 1.4 we encountered following error messages:cause: cmc-vif-downcode: F0459description: IOM 1 / 2 (B) management VIF 1 down, reason Module removedseverity: majorand:cause: named-policy-unresolvedcode: F4525239description: Po...

:                         Anyone  else having Cisco UCS 6140/5108 chassis problems that cause the fans to  act up  and the I/O card to have power and temp alarms ver1.3.0 even  when the environmental conditions are OK?