Unified Computing System Discussions

The failed drive was replaced.  This was replaced when the server was powered off.  The drive already had data in it.  The RAID5 array is on an M4 server (slots 3-6). Slot 3 is the disk that was replaced.  After powering up the server, we noticed we ...

Best practice to migrate service profile of B200 M3 SAN boot servers to new B200 M6 servers without any issues  

On my Router just want to reset the router password can anyone tell me how to do that.

We had similar issues Reported.We had Fabric A and Fabric B which has MDs 9710 on each side. FI-A is connected A side MDS and Fi-B is connected B Side MDs.On A side we had 5 members of Port channel out of 6 Ports went offline. This has caused due to ...

Hi All,is there a way to simulate the state link down of one Vhba in my service profile?In my environment I can't remove the FC uplink cause more then one service profile are pinned in port.Thanks!

Hello everybody,  Do you have a method to remove weak ciphers for SSH protocol in UCS fabric interconnector 6324 mini,  i have just the option to enable or disable SSH but not to configure ciphers, macs, e curves,  or some documentation that should c...

How to Migrate service profile from UCS 6200 to 6400/6500 FI.is there a script we can migrate the service profile, pools, policies to new FI. this new FI will run parallelly to the existing FI.we want to migrate one blade at a time. 

I got b200M3 profile installed with esxi 6.7. I want to unassgen the profile to b200M4. Are there any issues with this?  If it boots up I can do cleanup of drivers or update them while i upgrade to 7.0. Idea is save time and not recreate new service ...

Hi alli am planning to upgrade UCS Infra 4.1---4.1.3h----4.2.3once i am upgraded infra through above path can i  upgrade b and C host firmwares direct without going to intermediate ? 

We have an issue in 1 of our backup server which is rack mount server UCS C240 M4SX integrated to UCSM managed through UCS Central, is not booting up. The KVM IP is also not pinging hence we are unable to launch KVM. Physically the server is up but f...

Hello, I have a UCS 6200 that is in a bad configuration state.  It needs to be wiped.Both FI's boot as secondary and don't permit login.I'd like to just wipe the configuration but all of the documentation I've found requires access to nxos.Is there a...