Unified Computing System Discussions

Hi,I am attempting to apply the specified patches to UCS servers. Can I download them directly from the VMware site and apply them as I would with any other ESXi patches, or is there a specific custom build for Cisco?ESXi 5.0 / 5.1 / 5.5 / 6.0  VMSA-...

Hi,We have a cluster of Cisco Hyperflex systems and looking to replace two failed HDDs. These failed SAS drives are visible as "Blacklisted". Please advise if any special precaution is required while replacing these HDDs as I have seen some posts com...

We recently deployed UCSC 2.0(1t) to evaluate as we haven't been satisfied with Intersight up to this point. I recall seeing some information while evaluating that "Some features require a valid license after the evaluation period" (or something to t...

The failed drive was replaced.  This was replaced when the server was powered off.  The drive already had data in it.  The RAID5 array is on an M4 server (slots 3-6). Slot 3 is the disk that was replaced.  After powering up the server, we noticed we ...

Best practice to migrate service profile of B200 M3 SAN boot servers to new B200 M6 servers without any issues  

On my Router just want to reset the router password can anyone tell me how to do that.

We had similar issues Reported.We had Fabric A and Fabric B which has MDs 9710 on each side. FI-A is connected A side MDS and Fi-B is connected B Side MDs.On A side we had 5 members of Port channel out of 6 Ports went offline. This has caused due to ...

Hi All,is there a way to simulate the state link down of one Vhba in my service profile?In my environment I can't remove the FC uplink cause more then one service profile are pinned in port.Thanks!

Hello everybody,  Do you have a method to remove weak ciphers for SSH protocol in UCS fabric interconnector 6324 mini,  i have just the option to enable or disable SSH but not to configure ciphers, macs, e curves,  or some documentation that should c...

How to Migrate service profile from UCS 6200 to 6400/6500 FI.is there a script we can migrate the service profile, pools, policies to new FI. this new FI will run parallelly to the existing FI.we want to migrate one blade at a time. 

I got b200M3 profile installed with esxi 6.7. I want to unassgen the profile to b200M4. Are there any issues with this?  If it boots up I can do cleanup of drivers or update them while i upgrade to 7.0. Idea is save time and not recreate new service ...