04-20-2017 05:21 AM - edited 03-01-2019 01:09 PM
Hello!
My setup is:
Cisco UCS with 2x UCS-FI-6296UP (running 2.2(8f)A), each has 2 ports configured as channeled trunk ports, for the vlans of the vms running on some blades. The trunk ports are connected to a Nexus 5596UP.
Is it possible to query the VLAN-IDs which are configured on the Nexus side for the trunk ports from UCS-FI side with Powershell or any other tool?
Thanks in advance,
Lukas
04-25-2017 07:38 AM
Hi Lukas
You know how to find the answer to your question with UCS Manager GUI. Then there exists a wonderful command to find equivalent powershell commands:
http://www.thomasmaurer.ch/2013/10/cisco-ucs-powershell-convertto-ucscmdlet/
Walter.
04-26-2017 01:54 AM
Hello Walter,
thanks, but this is not exactly what i am looking for. I would like to query for VLAN-IDs that are configured on Nexus side to find out if there is a difference to those already configured in UCS Manager.
Greetings,
Lukas
04-26-2017 04:26 AM
Hi Lukas
What about CDP ? If there is a mismatch between Vlans on UCS and Nexus, you would see this, because the vlan's are not up !
Walter.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: