Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
587
Views
0
Helpful
1
Replies

UCS Manager 2.1(1A) VLAN traffic

Kevin Haas
Level 1
Level 1

‎08-16-2013 02:25 PM - edited ‎03-01-2019 11:12 AM

                   I have setup a vlan in Dual Mode, but traffic will only pass though 1 of the fabric interconnects. If I setup a VNIC to use vlan x and change the nic to use only fabric B, traffic will pass. Change the nic to use only fabric A and traffic will fail. Has anyone come across this before?

Thanks

Kevin

0 Helpful
1 Reply 1

richbarb
Cisco Employee
Cisco Employee

‎08-16-2013 04:16 PM

Hello Kevin,

Did you check out the Uplink configuration? (lacp negociation, status, layer1 issues)

If you are conecting the FI in diferrent upstreams swicthes, the vlan was created in both them?

Are you using disjoint Layer 2? (The configuration is by VLAN manager).

Are you using end-host-mode or switching-mode?

0 Helpful
Customers Also Viewed These Support Documents

Review Cisco Networking for a $25 gift card