when i finished to setup service profile i always get the same error:
Associate state: unassociated
Assigne state: failed
Configuration error: Connection-placement
There are not enough resources overall
Not enough vNICs available
I got that error whith and without dynamique VNIC.
Is someone got an idea??
Regarding this arcticle, this is the reason why the SP doesn't go active: "Unified Communications Virtualization Deployment Guide On UCS B-Series Blade Servers" (https://supportforums.cisco.com/docs/DOC-6158)
"This is important to note that a service profile that has two vNICs assigned would require a blade in a chassis with two IOMs connected to two fabric interconnects, and that service profile would fail to associate to a blade in a chassis with only a single IOM"
=> I resolved it by "Acknowledge chassis" in the chassis>genérale configuration. After it, the blade was connected with 2 I/O module.
=> I choose an expert configuration mode to add manually 2vNICS. MAC address is mapped with hardware default.
All works fine now !!
Thank you for your help.
I hope this discussion will help someone.
if you have Palo card with lots VNICs and still have the same issue, you might not have the enough links between IOM and FabricInterconnect, try this:
First of all you need 4 physical links between IOM and FabricIntercon.
then go to left pane -> Equipment tab -> equipment -> right pane -> policy
right click on your Chassis on left pane (e.g. "chassis 1") and re-knowlege it.
error msg should go away.
new to UCS central, while configuring the service profile I am receiving following error, can one help me to understand what mistake I am doing and how to get out of this.
- there are not enough resources overall
- the server does not
-the named VLAN cannot be resolved
I have already checked pool have sufficient resource, VLAN name also looks fine,