How are people managing their boot policies when dealing with SAN units with more than two controllers?
I have B200 M4/M5 blades with storage on HP 3PARs. Unfortunately, a separate team manages the storage. The 3PARs each have (4) controllers wit...
Any idea how to get S2D configured on here? Get-Disk is showing all the spinning drives as RAID and it looks like they need to have the BusType of SAS. Drives are Seagate ST2000NX0433 2TB drives connected to a Cisco 12G Modular Raid Controller with 4...
we are trying to globalize VLAN and VSAN.we are getting the below error when we click on Evaluate.
"Desired Domain group location can either be the domain group of selected domain or any domain group above in the hierarchy."
We are planning to move UCS FI from the existing 5548's to a new pair of 93128s.. Storage will stay as-is .. Ethernet connectivity to the N5K will be moving...
We plan to do the following:
0) have new port channels defined, with new interfaces in UCS...
Hi team,
i am doing the initial configs for the UCS FI - cluster is showing as UP however i can't ping from FI-A to FI-B and vice versa, Configuration is correct i have validated. (IP, mask and default GW)
Default GW device is not yet setup, Do...
I am trying to create a storage profile for C240 M5 rack mount server, so that i add only first two disks for RAID1 out of 8 disks. When i attach the storage profile to service profile and it throws below config errors.
One or more boot device(s) ...
Good evening, everyone. When I attempt to log into the CIMC on my C210 M2 using Internet Explorer 11 in Windows 10, the main page never loads. My credentials are accepted, but after that, the only thing I see is a status bar that spins indefinitely.
...
I received notice from a security person in my organization that the current firmware we're running on our UCS environment, which is 2.0(1w), has a few Sev1 Apache vulnerabilities, all of which are fixed in Apache version 2.2.22 or later. Unfortunate...
Hello -
I have a new C220 M4S server, whose SEL and CIMC logs are constantly filling up. The SEL fills up in under 20 minutes.
It is currently on FW 3.0(3f). Here are troubleshooting steps taken so far:
-Use HUU to update FW to 3.0(4a). CIMC...
Hi All,is it possible to restrict access for certain users to a specific blade on the UCS either via KVM or another method? we have AD integration enabled but i guess the problem will be that i give them access, then they will be able to access all ...
