cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
638
Views
0
Helpful
2
Replies

No signal on KVM (Cisco UCS B200 M5 Server)

d_ahmad
Level 1
Level 1

Hi, I have newly setup a server from scratch and have little technical knowledge so need help with the following;

 

When I load up the KVM console, a "no signal" screen appears. At one point I saw an alert on the UCS manager to say the resolution is too high, how do I overcome this? On the UCS it says the servers do not have power (an amber light is showing on the actual server. I have not setup a server profile, is this required at this stage?

 

 

Any help is very appreciated, thankyou.

2 Replies 2

d_ahmad
Level 1
Level 1

I plan to eventually map an exsi iso onto it

Steven Tardy
Cisco Employee
Cisco Employee

Does the KVM video console work during BIOS/POST?

Is it just one blade or multiple?

What OS is installed on the server?

What video driver and at what resolution is the OS trying to use?
I have seen some OS's (Linux) which try to drive an oddball (non 1080p/720p) video resolution which the OOB KVM video doesn't support.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: