THIS IS THE SOLUTION - DON'T WASTE TIME JUST DO  IT 

@Leo Laohoo's  solution works: Front-end Microcode IMG MGR: Preparing to program device microcode...Front-end Microcode IMG MGR: Preparing to program device[0]...29204 bytes.Front-end Microcode IMG MGR: Programming device 0...rrrrrrwsssssssspssssssss...

Facing same issue:  File "flash:c2960x-universalk9-mz.152-7.E4.bin" uncompressed and installed, entry point: 0x3000executing...Restricted Rights LegendUse, duplication, or disclosure by the Government issubject to restrictions as set forth in subpara...

Please verify you have IP ARP inspection trust enabled on the access client interface if the ARP Messages show MAC Address of 0000.0000.0000If they show the mac address of your DHCP Leasing router/device it will need an ARP ACL permitting the traffic...