I went inside ROMMON moved Access Point 1852i to part1 and part2 but my device still can't access the inside.I did a hardware reset but it didn't workDisplay messageNo valid user found, please configure a valid user from Controller% Authentication fa...
I configure Access Point C1131 in autonomous mode, I create free SSID for everyone to connect.Can I see a list of devices connected to my Access Point on the GUI?
I built Cisco Prime Inf and added my company's Access Point devices,If I don't have a license, will my Access Points be removed from Cisco Prime?Evaluation mode will limit what features and how long to try it?
If I place an obstacle in front of the Access Point, will the Signal Map show exactly what happens?In CMX I can only upload the building cross section, the Access Point moves into its right place, but I think the wave signal does not show properly if...
Please update to another versionVideo tutorialhttps://www.youtube.com/watch?v=zo91OsLpwwYIf you have already updated and the device is still not updating, create an RMA to replace the device
You can switch back to Mobility Express or Lightweight mode laterLightweight mode you will have to depend on the Controller you are usingCheck out my video:https://www.youtube.com/watch?v=zo91OsLpwwY
