Aaron_un
Level 1
Level 1
Member since ‎01-12-2021
‎09-16-2022

User Statistics

  • 36 Posts
  • 4 Solutions
  • 115 Helpful votes Given
  • 15 Helpful votes Received
Recent Badges
20 Replies
10 Helpful Vote
1 Helpful Vote
1 Accepted Solution
10 Replies
5 Replies

User Activity

I was wondering how to estimate the firewall throughput In an Independent Active Nodes deployment model...In this model ACI fabric symmetrically redistributes/PBR the traffic over the available pool of units...e.g. if we are deploying 2 FTDv100s in A...
To briefly describe this company has this main product, drones, who is revolving around in testing, management and mass produce TypeSpecificationHQ/Branches* 200 sites, different sizes between 10 to1500 EmployeesDrone Landing/Staging Ports800 sitesLA...
There are 3 different modes that we can insert the FW service node into the fabric, could you explain how different the config is for the last method(Independent Active Nodes), on the following two menus I included?If I am not wrong the last method i...
  This is the config on the IPN side(my question is not about the config on spines, we assume that they are fully confged)src: y0chub.cm/watch?v=HJJ8lznodN0"The spine interfaces are connected to the ISN devices through point-to-point routed interface...
I was looking everywhere for this Cisco Live Presentation...is it possible to share it?, I need this so bad!! Thanks Folks
Community Statistics
Member Since ‎01-12-2021 10:47 PM
Date Last Visited ‎09-16-2022 07:19 AM
Posts 36
Total Helpful Votes Received 15
Helpful Votes From