About ColeB20570

ColeB20570 · 02-13-2023

We recently purchased 10 refurbished Cisco AIR-CAP3702I-B-K9 AP's.When connected to our network, they don't automatically connect to the WLC. I attempted to manually input the controller IP information, but I'm not seeing the interface I'd expect to ...

ColeB20570 · 03-14-2022

I have multiple (around 9200 switches running the same version and basically the same configuration. On all the switches that are in use, I'm unable to get into enable mode via the console connection. I can do so via SSH using the Cisco CLI. The te...

ColeB20570 · 12-13-2021

There is a lot to unpack here so bear with me! Sh run and sh ver are attached. Recently replaced 5 older switches with 9200-48P's running 17.03.04. Ran into an issue with some older devices that are 100mbps and have static IP's. They are unable to co...

ColeB20570 · 02-14-2023

Here is the boot up.*Mar 1 19:53:02.771: %DOT11-5-EXPECTED_RADIO_RESET: Restarting Radio interface Dot11Radio0 due to the reason code 11*Mar 1 19:53:02.771: %DOT11-5-EXPECTED_RADIO_RESET: Restarting Radio interface Dot11Radio1 due to the reason code ...

ColeB20570 · 02-14-2023

We have definitely run into FN-63942. TAC suggested we change the date on the WLC to something like 2020. Being a medical facility, we are worried what other issue this might cause with medical devices on the wireless network. We are just holding out...

ColeB20570 · 02-13-2023

Our WLC is quite old. We have a 5500 running 8.3.133.0. We have over a hundred other CAP3702s running just fine.I am not able to factory reset. I've attempted to do that, but the commands are not the same. Whatever version of code installed on these ...

ColeB20570 · 03-17-2022

Richard, That did it! And I think I may even understand why Really appreciate your assistance. Regards, Cole

ColeB20570 · 03-16-2022

Richard, Where would you add that command, under conf t, but how would it be entered? Or do I specify local on the line con 0? When I type authentication ? I only see these options. command Allow the following CoA commands to be...

Member Since	‎06-10-2021 09:07 AM
Date Last Visited	‎02-15-2023 11:18 PM
Posts	23
Total Helpful Votes Received	5

User Statistics

User Activity

Refurbished AIR-CAP3702I-B-K9

Enable Password Not working via Console

100 mbps devices not working on new 9200 switches

Re: Refurbished AIR-CAP3702I-B-K9

Re: Refurbished AIR-CAP3702I-B-K9

Re: Refurbished AIR-CAP3702I-B-K9

Re: Enable Password Not working via Console

Re: Enable Password Not working via Console