About Spam-Mail

Spam-Mail · 11-15-2023

Spam-Mail · 10-19-2023

Is it possible to mix L2 MPLS and dark fiber for interpod links between data centers? The customer has reduced the OSPF cost for the dark fiber link to make it the primary connection, with MPLS as a backup. However, when simulating a failure scenario...

Spam-Mail · 10-11-2023

I am trying to converts ports from Ethernet to FC on UCS but the slider is starting from left to right instead of right to left. Is this the new firmware?.

Spam-Mail · 08-28-2023

Hi, I am running the topology below with EVPN/VxLAN Multisite on dcloud. Unfortunatley the two hosts in different sites and different VNI could not ping each other. However same VNI different sites the can ping each other and also different VNI same ...

Spam-Mail · 08-20-2023

I have a question, is the VXLAN packet packet labelled correctly? Which part is underlay and overlay below?.

Spam-Mail · 10-24-2023

It is possible....You configigure two L3out Pod1_L3out and Pod2_L3out.Configure BD1_Pod1 and BD2_Pod2. Each BD will be have an EPG configured for node interface for servers in there respective Pods only. BD1_Pod1 will be assocated with Pod1_L3out an...

Spam-Mail · 08-20-2023

"VxLAN act as the Overlay Data Plane. Then where you see VxLAN Network Identifier "VNI" this is the Overlay part." the UDP and SMAC/DMAC/SIP/DIP are VTEP PIPs. Why are they marked as Underlay? I thought that's the overlay and payload encapsulated ins...

Spam-Mail · 08-01-2023

Hello,When you replace an active APIC with a standby one, the replaced APIC switches off but does not wipe its configurations, as you previously explained. I have performed this procedure a couple of times in production. While switching on the replac...

Spam-Mail · 12-16-2022

from getpass import getpassimport sysimport telnetlibHOST = "192.168.73.131"user = input("Enter your telnet username: ")password = getpass("Enter password")tn = telnetlib.Telnet(HOST)tn.read_until(b"Username: ")tn.write(user.encode('ascii') + b"\n")i...

Spam-Mail · 12-15-2022

Try below: root@NetworkAutomation-1:~# cat script1import getpassimport telnetlibHOST = "Router IP address"user = input("Enter your telnet username: ")user = user.rstrip()password = getpass.getpass()tn = telnetlib.Telnet(HOST)tn.read_until(b"Username:...

Member Since	‎07-25-2021 01:38 AM
Date Last Visited	‎12-19-2024 09:02 AM
Posts	20
Total Helpful Votes Received	13

User Statistics

User Activity

..

ACI MultiPod IPN

Cisco UCS Unified Ports

Troubleshoot EVPN VxLAN in Multi-site

VXLAN Forwaring

Re: ACI Multipod L3Out Preference

Re: VXLAN Forwaring

Re: Replacing APIC whith Standby device

Re: errors while doing telnet on python 3 to CISCO router

Re: Python telnet