About Kasper Elsborg

Kasper Elsborg · 09-30-2023

Hi Guys, I am a bit puzzled about this. I have implemented 2 ISE nodes in Simple Two Node Deployment. Each node holds all personas. If I split it up, Ise03 holds, Admin and MnT, and Ise02 holds PSN personas, It still works, and clients gets AuthZ. N...

Kasper Elsborg · 03-12-2023

Hi I have an FTD, and an ASA, both connecting to same LAB infrastructure. ASA connects just fine, when using the anyconnect profile name, but the FTD fails. I get the "Untrusted server certificate"on both FW's however the FTD fails, only when connect...

Kasper Elsborg · 08-15-2022

Hi Community. I have manage to configure ISE to run 802.1x on the wired side. But when It comes to wireless, I am in doubt.The ISE live log suggest that the certificate is matched aginst AD, and EAP-TLS is up and running.But the "sh authen sess int g...

Kasper Elsborg · 08-08-2022

Hi community. I have installed an vWLC AIR-CTVM-K9, version 8.5.182.0 - straight from the .ova with standard config. in my ESXI 6.7, Meaning I haven't changed anything.I have a couple of AP's cisco AIR-CAP2702I-E-K9 - Cisco IOS Software, C2700 Softw...

Kasper Elsborg · 08-03-2022

Hi community. First, I'm studying the ISE so I'm simply a beginner. However I've managede to integrate my NAD's with Tacacs+ and authenticating with AD.It's a pure lab setup, with a ISE 3.1 and 4 switches, DC, with CA.Client1 (win10) have their certi...

Kasper Elsborg · 09-30-2023

Hi, So I've disabled the "Use "ISE Messaging Service" for UDP Syslogs delivery to MnT" and then I have livelogs again. Then I reissued certificates for ISE Messaging Service on both node, but using the pxgrid template(it has both server and client). ...

Kasper Elsborg · 09-30-2023

Hi @balaji.bandi First it's a test lab that I have running. The deployment was as described ISE02, and ISE03, holding all personas, PSN, MnT and Admin. Everythin works, Radius, and Tacacs, and there are logs in both Operation->live logs, and operatio...

Kasper Elsborg · 05-22-2023

hi adamscottmaster2013 After installing the two appbundles, how did you enter root access? Cheers Kasper

Kasper Elsborg · 04-05-2023

hi, all of a suddent I also experienced this problem, and only from one local pc. there is a setting in the anyconnect that will ommit the "captive portal detection"

Kasper Elsborg · 09-25-2022

I tend to think that:IPsec over GRE = GRE over IPsec tunnel modeIPsec VTI is GRE over IPsec tunnel mode without GRE-IP-header. It is duplicated by the IPsec-IP-header and can be saved on this by adding tunnel mode ipsec {ipv4 | ipv6} to the config. B...

Member Since	‎01-11-2022 11:10 AM
Date Last Visited	‎10-08-2023 11:01 AM
Posts	54
Total Helpful Votes Received	27

User Statistics

User Activity

ISE distributed deploy

Cisco Anyconnect, fails when using profile name

Am I running Dot1x or MAB?

AP not joining vWLC

ISE3.1 shows no endpoints

Re: ISE distributed deploy

Re: ISE distributed deploy

Re: Linux root access to ISE 2.6 and ISE 3.0

Re: Anyconnect VPN issue service restricted Please help

Re: IPsec, VTI, GRE and over