I have a cisco Cisco IOS XE Software, Version 17.03.05 on cisco ASR1001-HX (1SR) processorI am running this simple netconf yang code to get the runninmg config
import xmltodictimport xml.dom.minidomfrom ncclient import manager
router = {'ip': '192.11...
Hi,On ASR1001-HX, I have set management port eth0 ip as X.X.X.X and other to a regular interface GigabitEthernet0/0/3 as Y.Y.Y.Y.I also have netconf-yang enabled and username enabled with the following commands username netuser privilege 15 pass...
Hi,I am trying to use the operations data to query for the dhcp lease information. Below is the snippet of netconf-yang and the code. filter = """
<filter xmlns="urn:ietf:params:xml:ns:netconf:base:1.0">
<native xmlns="http://cisco.com/ns/yang...
Hi,I have created a DHCP Relay Provider within the User Tenant with the EPG type set as L3 External Network.The relevant BD in the User Tenant has been configured to Consume the DHCP Relay Provider.I have configure the edge routers connected to the A...
strange, but this code was working earlier.According to the netconf-yang protocol it should have returned the complete configuration. Anyways I tried your suggestions and still not getting anything.import xmltodictimport xml.dom.minidomfrom ncclient ...
Thanks @Marcel Zehnder . Normal SSH into the mgmt-interface is workingYes show ip route vrf Mgmt-intf those are setup correctly.If you see belowibm002-asr2#show ip route vrf Mgmt-intfRouting Table: Mgmt-intfCodes: L - local, C - connected, S - stati...