Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All, I have a question on the best (if any) approach to reduce my routing table. My network is configured such that each building on multiple campuses uses a 10.0.0.0/16 network. i.e. Bldg 5 uses 10.5.0.0/16, Bldg 6 uses 10.6.0.0/16, etc. Given ...
Hi Harold,We were just issued our IPv6 address block by Arin, and it came with three ASNs. Could you provide any information on why there are three (instead of just one)? Also, would I use one of those ASNs for my EIGRP routing on the inside or are ...
Hi Harold,We were just issued our IPv6 address block by Arin, and it came with three ASNs. Could you provide any information on why there are three (instead of just one)? Also, would I use one of those ASNs for my EIGRP routing on the inside or are ...
Hi Harold,We were just issued our IPv6 address block by Arin, and it came with three ASNs. Could you provide any information on why there are three (instead of just one)? Also, would I use one of those ASNs for my EIGRP routing on the inside or are ...
Rick, that's perfect. It took a few minutes for the lightbulb to go on after reading your explanation a few times, but that's exactly what I was looking for. Thanks!
