Just recently installed a C9130 with the EWC. When trying to download the images we are getting a error. I have tried this using TFTP,SFTP and HTTP methods all get the same issue. running config extract wireless profile image-download default
desc...
I've come across this "no ip redirects" command while labbing, this came up while learning how to configure HSRP. The Cisco page on HSRP speciifies this command as part of their config. Iv been doing to research on this and I think I have the basic...
we are refreshing hardware are several locations. Currently I'm looking at a 6504 chassis configured with mls qos lines in the config. These configs do not migrate over to the C9500s that we are putting it. I am not very knowledgeable in this area...
Issue ResolvedWe have FIPS enabled on the hardware at this location. FIPS had been enabled on the initial configuration put on the controller. We turned FIPS off and now able to join APs.
command returns no results, how can i check the product name? Thanks. Device#show wireless ewc-ap ap image predownload status
Device#Device#show ver
Cisco IOS XE Software, Version 17.03.06
Cisco IOS Software [Amsterdam], C9800-AP Software (C9800-A...
Ok so reading through some of this is appears that older versions did not allow redirects because the redirect package would end up using the actual IP of the active router in the HSRP group. This ends up loosing redundancy because now if that activ...
I will research why earlier versions of HSRP turn redirects off, this will likely help with some understanding on of the command. These answers really did help with understanding though and I appreciate the time you took to reply.
@Slideform wrote:IPSBNTOVRLP: A specified subnet 192.168.250.130 and mask 255.255.255.0 is overlapped with subnet 192.168.100.35 and mask 255.255.0.0. Why are the other two interfaces that are in the same subnet, not producing this error and is ther...
