Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
When an SD-WAN Router establishes a Control Connection with vManage or vSmart, it first creates a DTLS session with vBond.If the SD-WAN Router has two Colors/Interfaces, private1 and public-internet, and each has its own default route, how is the int...
Regarding Cisco SD-WAN NetFlow, I understand that, by default, the cflow configuration is applied on the vSmart side to collect ”Overlay” information.Is it possible to collect the information for both Overlay and Underlay, and send to a NetFlow colle...
I'm trying to configure NetFlow on Cisco IOS-XE SD-WAN. It seems I can configure NetFlow from vSmart with the following settings: cflowd-template NETFLOW
template-refresh 60
flow-sampling-interval 1000
collector vpn 3301 address 10.10.10.254 port ...
I would like to replace the current configuration on a Cisco IOS-XE SD-WAN router with an entirely new configuration. Is there a way to initialize the current configuration? I would like to conduct this from CLI not vManage Template.I ran the command...
Is it possible to specify the OS file located in usb0: for the OS installation when executing the request platform software sdwan software install command, instead of using the OS file in bootflash? If there are any precautions or points to note, ple...
Thank you for the information. I understand that booting from USB is not supported.As for the background of this question..For some reason, the router is referencing the OS file instead of the packages.conf file to boot as the following.and OS instal...
@Kanan Huseynli Thank you very much!Is it possible to confirm traffic access logs (such as Source IP, Destination IP, Allowed or Denied)?I am thinking of firewall logs.I would like to confirm if the logs show traffic flow from which source IP address...
