Hi,on one Nexus I have one interface in global routing table (GRT). That interface is connection to GRT part of the network. There is EIGRP adjacency between Nexus and rest of GRT network. Another interface is in VRF and there is EIGRP adjacencies in...
Hi all,question about PBR configuration. Can we apply template to same EPG, for example EPG-A to be Provider and Consumer.Is this supported, what would happened if this scenario was applied in template?ACI is version 4.2(7f).Thanks,Z
Hi all,we have some problems in our ACI-F5 design. Here are some facts on design:- Servers that we are using in F5 pools are connected on ACI Leafs- Servers has only default route pointing to F5 Self floating IP- F5 for this partition (VLAN) , has de...
Hi,Q-in-Q is supported on 1G and 10 G interfaces for that platform. Problem is when you configure sub interface, if you are using bigger number after dot, q-in-q for some reason is not available:router(config)#interface tenGigabitEthernet 0/1/1.10rou...
Interface that is or it will be in VRF is facing LAB environment and at the moment is flat eigrp with routes exchanged between lab and prod. All routes from prod are visible in LAB. Putting interface facing LAB into VRF has idea to brake routing betw...
Hi Paul,that nexus switch is boundary between VRF and GRT. Not sure what I would achieve adding existing GRT interface to VRF?There is one interface already in VRF and rest of interfaces are in GRT and eigrp running in GRT and VRF.
