Hello,Before updating my Cisco C9120AXE (fw was 16.x) I was used to change the country code with the following commands over SSH:enableconfigure terminalap dot11 24ghz shutdownap dot11 5ghz shutdownap country <country_code>no ap dot11 24ghz shutdownn...

hello,I have a C9120AXE-E Access point with the latest firmware (17.9), configured with EWC mode so that it is autonomous.I created a WLAN network on the AP, but I face a situation where my client are not able to connect this network. They are unauth...

HelloI face this issue that is indicated as not reproductible.What can I do to help ?Joel

Hello,I have a Cisco C9120AX Access Point and I would like to activate the FIPS mode.I have not seen any menu for that on the web page of the Access point, and not found the wanted command on the serial interface (I guess it is possible at least by t...